Thursday, January 10, 2019

Dust-free filling!



Execution of smooth walls and surfaces, renovation of rooms without troublesome dust? Yes, it's possible thanks to the innovative product CEKOL GS-250. It does not require grinding, which reduces dust and considerably speeds up the progress of renovation and finishing works.

Execution of smooth walls and surfaces, renovation of rooms without troublesome dust, this is possible thanks to the innovative product CEKOL GS-250. It does not require grinding, which reduces dust and considerably speeds up the progress of renovation and finishing works.

For some time there has been a dynamic development of finishing technologies. Thanks to the wide variety of materials, today's investor can make optimal choices. In the field of finishing coat, we also see a clear progress in technology. The technology of wet finishing plaster coating also deserves the attention of future investors. It is an excellent way to significantly reduce dust during renovation and finishing works. This is particularly important in the case of small renovations, when the tenants are not able to leave the premises for this time. Smooth gypsum for wet machining uses technology taken from the treatment of gypsum plasters in the final phase, ie the stage of sponging and removing milk. Gypsum plasters, however, require thicker layers, while the finish can be applied in a layer with a thickness of approx. 2 mm and obtain a smooth surface without grinding. The CEDAT company offer appeared in the SAFE SPOILING SMP PATCH GS-250.

When doing wet processing, there are a few important rules to keep in mind. After applying the coat layer to the substrate and initially leaving it, wait for the right moment when the surface reaches the initial hardness and using a sponge or brush, pull the milk to the surface and after a slight tarnish, remove it again, thus smoothing the surface. The aforementioned finish is a material with optimum hardness. It can be wet-wiped, but also use classical processing techniques by sanding bonded and dried material. The product is a perfect solution for people who are allergic to dust due to the dustlessness of the finish, both during the application and use of CEKOL GS-250 finished rooms.

The dust-free CEKOL GS-250 leveling coat is a unique product, since the coat does not need to be sanded in a classical way, and the surface of the walls to be painted ready in one day. Thanks to the wet processing method, the amount of dust generated is reduced to a minimum. After renovation, there is no mention of white dust, which requires persistent removal. The big advantage of wet machining is the ability to obtain a smooth surface without the need for grinding, while the smooth surface has optimal working and strength parameters.

Technology and stages of wet cleaning.

Prime

Prepare the mortar using approx. 9 liters of water for 20 kg of dry powder

Supplement cavities and larger irregularities.

Apply the appropriate layer in similar thickness over the entire surface of the walls or ceilings.

Wait and perform the sticking test of the hand.

Moisten the surface with water and then rub with a sponge, pulling out the milk.

Wait until the surface coats tarnish, and use a facade putty or float to start smoothing the surface.

We get a smooth surface without grinding.

Perform a test specifying the moment at which you can start wet cleaning.

1. The material is not suitable for mashing, it adheres to the fingers.

2. The material stops sticking, and in about 15 minutes, depending on the conditions, wet machining can be started.

3. The fabric does not stick to your fingers, start wet rubbing immediately.

PRODUCT FEATURES:

CEKOL GS-250

Dust-free finishing coat

Renovation without dust and dust, fast and clean

Smooth and even surface - no grinding

Optimal working and strength parameters

Dust-free finishing coat, for wet processing and the classic method

For manual and machine application.

Layer thickness from 1 to 10 mm

Consumption 1.5 kg / m² / mm